Switching On The Via Go - Alber via GO V24 Gebrauchsanweisung

2.7 Switching on the via GO

To switch on the via GO, press and hold the On/Off button for at least one second [13].
This button is now illuminated green until the via GO is switched off.
If the system is switched on, it is checked for possible errors [14]. In the course of the
check, all segments [14a to 14e] light up briefly, one after the other, on the LED display.
After this, the currently set speed is displayed for 3 seconds as follows:
LED element Set speed
14a flashes 1.5 km/h
14a and 14b flash 2.0 km/h
14b flashes 2.5 km/h
14b and 14c flash 3.0 km/h
14c flashes 3.5 km/h
14c and 14d flash 4.0 km/h
14d flashes 4.5 km/h
14d and 14e flash 5.0 km/h
14e flashes 5.5 km/h
The via GO is not ready for use and shows you the remaining battery capacity via the LED
segments [14a to 14e] until it is switched off. The following indications mean:
LED element
14a to e are illuminated
14a to d are illuminated
14a to c are illuminated
14a and b are illuminated
14a is illuminated
14a flashes
If an error is detected during the system check, this is also indicated by
the segments [14a to 14e]. For details, see also 3.
Residual capacity of the bat-
tery
80 to 100 percent
60 to 80 percent
40 to 60 percent
20 to 40 percent
10 to 20 percent
10 percent or less
9