Sequence Of Measurements - Drivetest Fm200 Handbuch

Drive Test GmbH München Handbuch / Manual FM200 Seite 87 von 99
The setting details are found under "Extras/ Result export options".
File format:
Standard setting is CSV format. Further processing with MS Excel is possible. An alternative
format is Q-DAS.
Automatic Export:
The automatic export is performed during uploading of measured data from display unit.
Details can be set in this menu.
Manually controlled export:
Alternatively to the automatic export, it is possible to trigger the export manually ("File/
Export/ CSV Export").

5.10 SEQUENCE OF MEASUREMENTS

Measurement sequence is intended for all those objects, who have to be measured at
several points like train doors, bus doors, automatic doors, etc.
Measurement sequence can be found under: "File/ Sequence" or clicking on the sequence
symbol "Symbol" (hand with a sheet of paper).
Measurements can be uploaded into the PC within the sequence window.
On the right, the loaded measurements are displayed in a table.
The middle area is to specify the measurement points including the limit to be applied.
On the left side area sequence properties and remarks can be entered, like guideline to be
applied, tester, customer, etc.
Version 7.1 Archive: FM200_DE_EN_V7.1