Main Menu; Measurement Data; File Name; Location Of Files - Drivetest Fm200 Handbuch

Drive Test GmbH München
5.4

MAIN MENU

After starting PinchPilot by double click on the PinchPilot icon the main menu is displayed:
Menu bar:
At the upper screen margin there is the menu bar. This bar offers access to all PinchPilot
functions.
Tool bar:
The tool bar is below the menu bar. This bar offers a fast mouse access to often used
functions. All functions can also be activated in several steps via menu bar. The tool bar can
be modified by the user (right mouse click opens menu).
Four diagrams:
In the middle of the screen there are four diagrams. They represent three single
measurements and additionally a fourth diagram displaying all three measurements. Each of
the four diagrams can be displayed in a single diagram view.
Results:
The result values are displayed in a table in the lower screen area. Result values are discrete
values needed for evaluation purposes based on the active guideline, such as the peak force
of a measurement. Each of these values is evaluated on the basis of the active guideline and
indicated to be OK or not OK. Besides the values of single measurements, the average
values of the three measurements are also evaluated. The total evaluation result is displayed
in a separate result field with a significant OK / not OK display.
5.5

MEASUREMENT DATA

Measurement data is found in measurement data files. Within the software PinchPilot the
expression "file" is equivalent with measurement data file.

5.5.1 File name

The name of measurement data files is composed of several components:
aaaa bbb cc (dd).ppd
aaaa .. Serial no. of the sensor. This part of the name can be activated or deactivated. It is set
under "Extras/ Options/ Sensor/ Serial No. in file name". The serial no. as part of the
name is especially important when more than one sensor is in use. When only one
sensor is used, this feature should be deactivated.
bbb ... Continuous block number. This number is incremented at every upload session
(transfer of measurement data from display unit to the PC). The block no. can be set
under "Extras/ Options/ Sensor/ Bloc No.".
cc ... Number of the measurement (00-99)
(dd) ... Index for single auto-sequence (00-99)
ppd ... Type specific file extension: PinchPilot data

5.5.2 Location of files

Before uploading data, a destination directory can be selected ("Sensor/ Load Measure Data/
Search"). At next upload the selected directory will be used.
When loading measurement data files stored in the PC, the location can be selected freely.
At the next loading the selected directory will be used.
Version 7.1
Handbuch / Manual FM200 Seite 78 von 99
Archive: FM200_DE_EN_V7.1