Testing Measurement Function; Installation Of Pc-Software Pinchpilot; Transport; Placing Out Of Operation - Drivetest Fm200 Handbuch

Drive Test GmbH München

1.2.2 Testing measurement function

For an initial functional test, follow these steps:
connect sensor with the display unit,
turn on the display unit by briefly pressing the display unit push button,
after initialisation start a measurement by pressing the push button of the display unit,
put a load on the sensor and remove it,
after the measurement duration has expired, the peak force measured is displayed
1.3

INSTALLATION OF PC-SOFTWARE PINCHPILOT

For installation and interface setting, refer to section "PC-Software PinchPilot/Installation".
1.4

TRANSPORT

For any transportation of the system the transportation case should be used.
1.5

PLACING OUT OF OPERATION

When the instrument will not be used for a longer period of time, please regard these
measures:
Check if data to be used is still stored in the display unit (if so, upload data)
SEB2: remove battery; SEB2.2: Charge battery
The instrument should be stored in a dry environment within the limits of storage
temperature (refer to "Technical Data").
1.6

BRINGING INTO SERVICE

SEB2: insert battery; SEB2.2: Charge battery
Version 7.1
Handbuch / Manual FM200 Seite 58 von 99
Archive: FM200_DE_EN_V7.1