DriveTest FM200 Handbuch Seite 83

Drive Test GmbH München
Set on system time:
The real-time clock contained in the display unit is set to the PC's system time. This setting is
of great importance since every measurement gets a time stamp, thus the time of the
measurement is documented.
Guideline:
According to the sensor type the appropriate guidelines are selectable.
Limit:
According to the guideline the appropriate force limit values are selectable.
Mode:
Selectable modes are:
Single measurement
Single measurement with auto sequence
Dual measurement
Dual measurement with auto sequence
Triple measurement
Triple measurement with auto sequence
Quintuple measurement
Quintuple measurement with auto sequence
This setting can also be modified via the display unit.
Multiplex-Display:
If this option is active, the display of the display unit will toggle between the peak and the
effective force. The effective force is the average force during which the force is greater than
the trigger value.
Version 7.1
Handbuch / Manual FM200 Seite 83 von 99
Archive: FM200_DE_EN_V7.1