Language; Interface Setting Related To Display Unit - Drivetest Fm200 Handbuch

Drive Test GmbH München

5.1.3 Language

Available languages are German, English, French, Italian and Spanish. The setting is found
under: "Extras/ Language" ("Extras/ Sprache").

5.1.4 Interface setting related to display unit

Please follow these steps:
Connect display unit to your PC (COM, USB)
Normally, the display device is automatically recognized by the PC. If not, please
check COM port of USB to serial converter on your PC: "Settings/ Control panel/
Device manager/ COM ports"
Connect/ disconnect USB connector and note no. of COM port used
Start PinchPilot, go to "Extras/ Options/ Sensorbox/ Port" and select appropriate port
no.
Check connection to display unit: Turn on display unit, go to "Sensor/ upload measurement
data"; state message in lower left corner must be "Ready":
Version 7.1
Handbuch / Manual FM200 Seite 76 von 99
Archive: FM200_DE_EN_V7.1