Optimum OPTidrill B 16H Betriebsanleitung Seite 92

OPTIMUM
M A S C H I N E N - G E R M A N Y
Malfunction
Working spindle rattling on
rough piece surfaces
GB B16H | B16HV
Page 92
®
Cause/
possible effects
• Excessive slack in bearing
• Working spindle moves up and
down
• Adjustment strip loose
• Clamping chuck is loose
• Tool is blunt
• Workpiece is loose
Translation of the original instructions
Solution
• Reduce bearing clearance or
replace bearing
• Readjust bearing clearance (fixed
bearing)
• Adjust strip to the correct slack
using the adjusting screw
• Check, re-tighten.
• Sharpen or replace tool
• Clamp the workpiece firmly.
Version 1.1.8 dated 2018-9-13
Malfunctions