Inhaltsverzeichnis
Werbung
a
3
1
2
a
DECOMPRESSION LEVER
5
4
B
6
1
2
5 mm (0.2 in)
E
1
B
1 - 15
3. Install:
Decompression lever 1
G
Boot 2
G
Decompression lever holder (upper) 3
G
Collar 4
G
Screw 5
G
Nut 6
G
NOTE:
Install the collar with its thread portion a fac-
ing the nut and with the lithium soap base
grease applied to its outer circumference.
4. Install:
Decompression lever holder (lower) 1
G
Bolt (decompression lever holder) 2
G
4 Nm (0.4 m · kg, 2.9 ft · lb)
NOTE:
The decompression lever holder should be
installed according to the dimension as shown.
5. Install:
Decompression cable 1
G
NOTE:
Apply the lithium soap base grease on the
G
decompression lever sliding surface and the
decompression cable end.
Install the decompression cable after pass-
G
ing it through the boot hole a.
6. Inspect:
Decompression cable routing
G
Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
7. Adjust:
Decompression lever free play
G
Refer to "DECOMPRESSION LEVER
ADJUSTMENT" section.
8. Install all of the removed parts.
GEN
INFO
Werbung
Inhaltsverzeichnis
