Yamaha YZ Serie Fahrer- Und Wartungshandbuch Seite 164

FRONT BRAKE ADJUSTMENT
NOTE:
If bleeding is difficult, it may be necessary
to let the brake fluid system stabilize for a
few hours. Repeat the bleeding procedure
when the tiny bubbles in the system have
disappeared.
w
Check the operation of the brake after
bleeding the brake system.
3. Install:
EC362040
FRONT BRAKE ADJUSTMENT
1. Check:
Standard position
2. Adjust:
Brake lever position adjustment steps:
9Loosen the locknut 1.
9Turn the adjusting bolt 2 until the lever
9Tighten the locknut.
cC
Be sure to tighten the locknut, as it will
cause poor brake performance.
3-18
j. Add brake fluid to the level line on the
reservoir.
9Protector (rear brake)
9Diaphragm
9Master cylinder cap
9Brake lever position a
Brake lever position a a :
95 mm (3.74 in)
9Brake lever position
position a is within specified position.
Locknut:
5 Nm (0.5 m•kg, 3.6 ft•lb)
INSP
ADJ
Extent of adjutment
76 ~ 97 mm
(2.99 ~ 3.82 in)