Qualification Of Personnel; Target Group - Optimum OPTIdrill B 40GSP Betriebsanleitung


rotating parts,

with electrical voltages and currents.
We have used construction resources and safety techniques to minimize the health risk to per-
sons resulting from these hazards.
If the geared drill is used and maintained by the staff who are not duly qualified, there may be a
risk resulting from incorrect or unsuitable maintenance of the geared drill.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must

be duly qualified,

strictly follow these operating instructions.
In the event of improper use

there may be a risk to the staff,

there may be a risk to the machine and other material values,

the correct function of the geared drill may be affected.
Always disconnect the geared drill if cleaning or maintenance work is being carried out.
WARNING!
The geared drill may only be used with the safety devices activated.
Disconnect the geared drill immediately whenever you detect a failure in the safety
devices or when they are not mounted!
All additional devices installed by the operator have to be equipped with the prescribed
safety devices.
This is your responsibility being the operating company!

Safety devices on page 62
1.6

Qualification of personnel

1.6.1

Target group

This manual is addressed to

the operating companies,

the users,

the staff for maintenance works.
Therefore, the warning notes refer to both operation and maintenance of the geared drill.
Determine clearly and explicitly who will be responsible for the different activities on the
machine (operation, maintenance and repair).
Unclear responsibilities constitute a safety risk!
Always disconnect plug of the geared drill from the electrical power supply. This will prevent it
from being used by unauthorized staff.
The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the opera-
tion in the standard mode must only be performed by the operator if it is indicated in these
instructions and if the operating company expressively commissioned the operator.
EN B40 GSP
60 Translation of original instruction
Safety
Version 2.1.2 - 2021-09-22