3.8.1
Checks
Check the geared drill as indicated under
Check the geared drill as indicated under
3.9
Coolant pump
ATTENTION!
The coolant pump also delivers if it turns in the wrong direction. Due to the wrong
turning direction the pump is destroyed within a short time.
3.10
Warming up the machine
ATTENTION!
If the geared drill and in particular the drilling spindle is immediately operated at
maximum load when it is cold it may result in damages.
If the machine is cold, e.g. directly after having transported the machine, it should be warmed
up at a spindle speed of only 500 1/min for the first 30 minutes.
EN
B40 GSP
76
Coolant pump
Fill in coolant
Img.3-4: Coolant pump, coolant filler hole
Translation of original instruction
Safety check on page 64.
Oil level of the speed gear on page 90.
Version 2.1.2 - 2021-09-22