Preparation; Restarting; Inspection And Maintenance - Optimum OPTIdrill B 40GSP Betriebsanleitung

6.1.1

Preparation

WARNING!
Only carry out work on the machine if it has been unplugged from the mains power

supply. Disconnecting and securing the geared drill. on page 66
Attach a warning sign.
6.1.2

Restarting

Before restarting run a safety check.

Safety check on page 64
WARNING!
Before starting the machine you must be sure that

no dangers generated for persons,

the machine is not damaged.
6.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where?
Start of shift
after every
maintenance
or repair work
every day
Maintenance
Version 2.1.2 - 2021-09-22
What? How?


Lubricate the lubricating nipples on the lathe saddle.
Img.6-1: Lubricating nipple drill head
Translation of original instruction
Safety check on page 64
Lubricating nipple
B40 GSP EN
89