Deditec USB-BITP-200 Hardware Dokumentation Seite 228

4.4.1. Configuration of the DELIB CLI
Before the first use of the CLI DELIB the "delib_cli.cfg" must be
edited with a text editor.
Configuration on Windows / Linux
On windows machines you can find the "delib_cli.cfg" after the
installation of the DELIB Driver library in this directory "C:
\Programme\DEDITEC\DELIB\programs\cli\".
For Linux you can find the needed "delib_cli.cfg" in the
downloadable "DELIB CLI for Linux" Zip-archive from our Website.
Content of the "delib_cli.cfg":
moduleID=14;
moduleNR=0;
RO-ETH_ipAddress=192.168.1.11;
moduleID
The moduleID is the corresponding number of the desired module
and can be read in the "delib.h"
On windows you can find the "delib.h" in this directory: "C:
\Programme\DEDITEC\DELIB\include\".
On linux you can find the "delib.h" in the "DELIB CLI for Linux" Zip-
archive from our Website.
moduleNR
The moduleNR can be set in the DELIB Configuration Utility.
This number is needed to identify identical hardware.
The default value is 0.
RO-ETH_ipAddress
This entry is only needed when modules with ethernet interface are
being used.
The IP-Address can be changed with the DELIB Configuration
Software | Seite 228