Deditec USB-BITP-200 Hardware Dokumentation Seite 166

4.2.8.2.1. Module configuration USB
The configuration of USB modules is only necessary to use multiple
modules of a USB product family (for example, 2x USB-RELAY-8)
in a system.
If there is only one USB module, or multiple USB modules from
different product families (such as RO-USB-O16 and USB-RELAIS-
8) in the system, no configuration is necessary as the products are
clearly identifiable via the module ID.
After clicking on the product you wish to configure, you will see all
possible settings on the right.
The "Current module
stored in the module. This number is for identification purposes and
must be configured differently for identical USB products.
A new number between 0 and 255 can be assigned to the product
with the item "New module
products have the module no. 0.
With "Set New Module
number" is written to the module.
Via the selection box
you can specify how often the DELIB tries to communicate with the
module in case of an error.
number" refers to the module number
number". In the delivery state, all
No.", the currently selected
"Transfer attempts (for all USB
"New module
modules)",
Software | Seite 166