Automatic Search - Deditec USB-BITP-200 Hardware Dokumentation

4.2.8.2.2.1. Automatic search

Behavior of the DELIB Configuration Utility when using multiple
network adapters in a window system.
When searching for DEDITEC Ethernet modules via the PC's
primary network adapter (ETH0), the network settings of the
DEDITEC product are ignored.
This means that our Ethernet products are found even if they are not
on the same network due to the IP address and subnet mask.
If, on the other hand, the Ethernet module is connected to a
different or non-primary network adapter (for example, ETH1), the
network configuration of the Ethernet module must be valid for the
module to be found.
Attention:
If a laptop is used, the integrated WLAN adapter is usually
configured as the primary network adapter.
This means that modules that are connected to the laptop via a LAN
cable are often not recognized because the network configuration is
not valid.
For module installation, it is recommended to disable the WLAN
adapter at short notice.
The following graphic shows an overview of the automatic search.
Software | Seite 178