Deditec USB-BITP-200 Hardware Dokumentation Seite 102

4.2.2.3. General
1. Timeout status ( "Disabled", "Enabled" or "Occured").
2. Enables or disables the timeout protection.
3. Timeout time for timeout protection.
4. Status for "Automatic read / write" (flashing when "Automatic read
/ write" is activated).
5. The "Automatic read / write" check box is used to determine
whether the measured data should be read / written automatically.
6. Manual reading / writing. Only active if "Automatic read / write" is
deactivated.
7. The currently selected module can be configured here via the
DELIB Configuration Utility.
8. If supported by the module, you will receive detailed debug
information.
9. This gives you detailed information about the selected module.
Software | Seite 102