Emissions - Optimum OPTIdrill DH 35G Betriebsanleitung

Spindle speeds ± 5% [ rpm ]
at ~ 60Hz connection
Gear stages / motor stages
Spindle sleeve feed
Environmental conditions temperature
Environmental conditions
Relative humidity
Gear operating material
Operating material
Toothed rod and drill column
Coolant equipment
Coolant system
2.1

Emissions

CAUTION!
The user must wear noise protection and hearing protection.
The A-weighted sound pressure level L
The A-weighted sound power level L
INFORMATION
This numerical value was measured on a new machine at 2000 rpm in one meter distance
under the operating conditions specified by the manufacturer. The noise behaviour of the
machine might change depending on the age and wear of the machine.
Furthermore, the noise emission also depends on production engineering factors, e.g. speed,
material and clamping conditions.
INFORMATION
The following factors influence the actual degree of the noise exposure of the operator:
Characteristics of the working area, e.g. size of damping behaviour,

other noise sources, e.g. the number of machines,

other processes taking place in proximity and the period of time, during which the operator

is exposed to the noise.
Furthermore, it is possible that the admissible exposure level might be different from country to
country due to national regulations.
This information about the noise emission should, however, allow the operator of the machine
to more easily evaluate the hazards and risks.
EN
DH35G
70
90 ǀ 130 ǀ 290
430 ǀ 500 ǀ 740
1600 ǀ 2400
3 steps - 0.05 - 0.15 mm / rev
approx. 4.5 litres Mobilgear 629
Acid-free oil

approx. 6 litres
400V ~50 Hz
is 83 to 86 dB.
pA
is 101 to 104 dB.
WA
Translation of original instruction
DH35G
4 / 4
5 - 35 °C
25-80%

Lubricant on page 127
Lubricant on page 127
40 W
Technical specification
Version 1.0.4 - 2022-02-15