Garbin PICCOLO Betriebs- Und Wartungsanleitung Seite 41

4 - DIGITAL OVEN PROGRAMMING
the temperature parameters of the cooking cycle that has just ended,
otherwise, by pressing the START/STOP key the buzzer is silenced and
the display turns back to normal visualization: the CHAMBER display
indicates the current temperature value inside the cooking chamber
(value detected by the probe, TEMPERATURE icon is flashing) and the
TIME/HUMIDITY display indicates the END time value (TIME icon per-
manently green lit).
15 minutes after the end of every cooking cycle: (by pressing the
START/STOP key or automatically ended for timed cooking) and if no
other key is pressed, the oven turns OFF. In order to restart control it is
enough to press the ON/OFF key.
4.3 Programmed operation
The card can store 99 recipes.
4.3.1 Storing a new program
The following procedure must be followed in order to store a new co-
oking program:
-Press once the RECIPES key to access the programming mode. The P01
recipe is flashing on the CHAMBER/PROGRAMS display (PROGRAMS LI-
BRARY icon permanently red-lit).
Increase up to the value of the recipe to be used for instance P25 and
after a 5 seconds timeout the specific recipe is confirmed (or by pres-
sing the P6 RECIPES key). The data associated to the recipe will appear
on the display.
If unchanged temperature is 30, time is END, humidification is OFF, step
F1.
If decreased under the P01 value, MAN is displayed (5 seconds timeout
exits the recipes and takes us to manual mode). By continuously pressing
the decrease key, the value decreases rapidly, all the inferior programs will
be shown up to MAN.
- Only on display 1 for example P01 will be visualized with its related icons
all turned off as on display 2 all turned off.
- Now you can introduce or change the temperature values (paragraph
3.2), time values (paragraph 3.3) and humidification (paragraph 3.4), coo-
king steps (paragraph 3.5).
- To store keep pressing the RECIPES key for 4 seconds. Storage is con-
firmed by the buzzer sound for several seconds and by the visualization
on the display of the program number that has previously been selected
alternating with MEM.
- Press once the RECIPE key in order to enable visualization of the recipe in
which the oven is operating.
The following procedure must be carried out in order to store a new co-
oking program:
- Press once the RECIPES key to access the
programming mode. The CHAMBER/PROGRAMS display (PROGRAMS LI-
BABRY icon lit) indicates ''P1'' .
- The number of the desired program can be selected using the INCREASE
and DECREASE keys.
- Press the RECIPES key for 4 seconds in order to enter the creation mode
of the previously selected program, setting the temperature values (pa-
ragraph 2.1), time values (paragraph 2.2) and humidification values (pa-
ragraph 2.3).
Several steps that make up the program (F1, F2, F3) can be set as descri-
bed in paragraph 3.2
- To store keep pressing the RECIPES key for 4 seconds. Storage is confir-
med by the buzzer sound for several seconds and by the visualization on
the display of the program number that was previously selected.
EN
41