Garbin PICCOLO Betriebs- Und Wartungsanleitung Seite 27

1 - INTRODUCTION
• The installation and/or all repairs or calibration that might become ne-
cessary must be performed with maximum diligence and attention by
qualified personnel.
For this reason we advise you to always contact the Dealer who sold
you your machine and make sure you specify the issue, the model and
the serial number of your oven.
• In case of repair and/or replacement of components, extraordinary
maintenance, fault or malfunction, contact only authorized personnel
indicated by the producer since only they have the necessary professio-
nal qualifications.
• Only use original spare parts.
• Before the installation, make sure the power and water distribution va-
lues are compatible with the values indicated in the technical data tag.
• The electrical safety of the oven is ensured by means of a connection
to an efficient grounding system (it is reminded that it must be periodi-
cally inspected) and it complies with the National and local regulations
in force.
• The operation and supervision of the oven during its use must be en-
trusted only to specifically trained people.
• Avoid installing the oven next to heat sources such as: deep fryers,
open fires, etc.
• Do not obstruct the exhaust openings for any reason, do not prevent
the dispersion of heat and do not obstruct the steam exhaust of the
oven.
• Ask the installer for instructions for the correct use of water softener/
decalcifier.
(Warning: a flawed procedure of regeneration of the resins may
cause corrosion of the equipment).
• Before starting it for the first time it is necessary to perform thorough
cleaning of the oven:
- externally it must be cleaned only with a wet piece of cloth;
- the inside of the cooking chamber must be cleaned with water;
- under no circumstances can wire wool be used to clean the oven.
Failure to observe these fundamental rules may compromise
the safety of the oven and therefore cause damage to the user.
The producer company declines all responsibilities in case of
failure to observe the norms contained in this guide, both by
the user and the technician in charge with the installation and
no potential incident or damage caused by such non complian-
ce can be attributed to it.
The producer declines all responsibility for potential inaccura-
cies contained in this manual caused by transcript or printing
errors.
Furthermore it reserves the right to make the product changes
it considers useful or necessary, without compromising the es-
sential characteristics of the product.
EN
27