Manual Operation - Garbin PICCOLO Betriebs- Und Wartungsanleitung

4 - DIGITAL OVEN PROGRAMMING

4.2 Manual operation

When the oven is OFF, OFF is visualized on the CHAMBER display, eve-
rything else is unlit.
The oven is turned ON by pressing the ON/OFF key.
When the oven is ON, the CHAMBER display indicates the current tem-
perature value inside the cooking chamber (value detected by the pro-
be, TEMPERATURE icon flashing). The TIME/HUMIDITY display indicates
the time value END (TIME icon permanently lit).
− press the INCREASE or DECREASE key in order to set the temperature
value (paragraph 2.1.).
− press the TIME key in order to enable cooking time setting (paragraph 2.2).
− press START/STOP key in order to start a cooking cycle (paragraph
2.4.).
− You can have humidification during a cooking cycle for as long as the
HUMIDITY key is pressed (keys P7 and P8 deactivated).
4.2.1 Setting a temperature value
When the oven is ON, press the INCREASE or DECREASE key in order to
immediately enable temperature setting (temperature can be set from
30 °C to 260 °C).
In case of the initial turning on (initial turning on means every time the
oven is turned on by pressing the ON/OFF key) the CHAMBER display
(TEMPERATURE icon permanently lit) shows
the value of (30 °C) flashing.
While in case you have just finished a cooking cycle, the display shows
the previously set value flashing.
While adjusting, the values on the display are flashing.
A five seconds' timeout or pressing the P3 key (TIME) confirms the set
value and brings back the visualization of the current temperature in
the cooking chamber (the TEMPERATURE icon is flashing).
Once the value is confirmed, the visualization of the display values is
permanent.
Pressing the ON/OFF key turns the card OFF and the new settings are
not saved.
4.2.2 Setting cooking time values
To set a cooking time, press the TIME key, the TIME display (CLOCK icon
permanently red lit) shows the value END. The time can be set within a
range from 00 hours and 01 minutes to 15 hours and 59 minutes.
Press the INCREASE or DECREASE key in order to enable setting of a
time value.
If the value is lowered under a minute, the display shows END and then
INF.
END is used in the programmed cooking by steps in order to disable
the step.
INF means that an infinite time was selected, i.e. the oven will not stop
working until it is stopped by pressing the START/STOP key.
While adjusting, the values on the display are flashing.
The confirmation of the value is performed by pressing the TIME key or
after a 5 seconds timeout.
Once the value has been confirmed the display values are permanently
lit.
The CLOCK icon is permanently red-lit.
Pressing the ON/OFF key turns the card OFF and the new settings are
not saved.
EN
39