Garbin PICCOLO Betriebs- Und Wartungsanleitung Seite 32

2 - INSTRUCTIONS FOR INSTALLATION AND MAINTENANCE
2.5 Substitution of certain components
CAUTION!
The substitution and regulation of components are operations
of extraordinary maintenance and therefore they must be per-
formed by an authorized technician.
Before starting any repair or maintenance action the general
switch must be disconnected in order to cut off the power sup-
ply to the oven.
Close the water supply faucets.
EN
Removal of door
The hinges (A) are equipped with two mobile staples (B) that clasped
to the sections of the hinges (C), when the door is completely open,
block them.
The door is lifted towards the outside carrying out then the two mo-
vements described (Fig. 6); in order to perform these actions hold the
sides of the door close to the hinges.
To reassemble the door, insert the hinges in their specially devised
slots.
Before closing the door remember to remove the two mobile staples
(B) that were used to clasp the 2 hinges.
Oven lamp
Unscrew the protection cap (A - Fig. 7) protruding inside the oven
and then reach the light bulb. After having replaced the light bulb,
re-assemble the protection cap (A).
Heating element
The resistor is removed by unscrewing, from inside the chamber, the
screws that block it; the electrical connections are accessible from be-
hind once the back panel is removed.
32
Oven fan
Once the back panel of the oven is removed, from inside the oven, remove
the pan support and the fan protection. Unscrew the central nut, if needed
also unscrew the lateral screws fixing it on the crank shaft, which sets the fan
loose. Pull the fan out and unscrew the screws of the motor flange.
Gasket
Manually extract the gasket from its position and replace it with the new one
without using tools.
A
A
C
B
Fig. 6
Fig. 7