System Shutdown; Camera Viewing - Dedicated Micros D4 Anleitung

System Shutdown

If the D4 needs to be switched off for any reason, the shutdown procedure
needs to be followed:
1. Select Enabled in the System Shutdown option.
2. When the pop-up menu appears, press and hold Camera 1 for five seconds
to shutdown.
3. The message 'It is now safe to switch off your unit' is displayed, switch the
D4 off at the wall.
WARNING: Data loss or disk failure may occur if a system shutdown is not
performed before removing power.
DST
Daylight saving time can be adjusted automatically or manually. By default, the
automatic setting will go forward one hour on the last Sunday in March at
01:00, and one hour back last Sunday in October at 02:00. The default
automatic settings can be changed. If the country where the unit is located doe
not use DST then select manual.
14

Camera Viewing

An option is available to view all cameras or selected cameras. All the cameras
are viewed by default. Cameras removed from viewing do not affect the
cameras being recorded.
To Change the Cameras to be Viewed:
1. Press the cursor key to change the edit field to Selected Cameras.
A menu will display the cameras to be viewed.
2. Press the Camera key to toggle the camera in or out of the viewed
sequence. This camera will be displayed. A filled box denotes cameras that
can be viewed.
Note: Cameras removed from view are not displayed on the main or spot
monitor in live or playback mode, multiscreen displays will show a blank
segment.
Important Note: If cameras are initially removed from camera viewing but are
recorded, to view these cameras in playback the cameras must be enabled in
this option.
Tip: It is advisable to set a password to stop this setting being altered by
unauthorised personnel.