Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ATTENTION!
Machine
transport,
storage
personnel
adequate instruction and training on
the use of lifting systems and the use of
personal protection equipment suitable
for the type of operation carried out
(e.g. overalls, safety shoes, gloves and
helmet).
D1.1
Transport: instructions for the carrier
During the journey the tightness of the fi xing systems
must be checked several times, and in particular:
•
A few km after the start of the journey;
•
In case of sudden temperature changes;
•
In case of intense cold;
•
In case of particularly rough roads;
When removing the anchoring systems, make sure the
stability of the machine's parts does not depend on the
anchoring and, therefore, that this operation does not
cause the load to fall off the vehicle.
ATTENTION!
Do not stand under suspended loads
during loading/unloading operations.
Unauthorized personnel must not enter
the work area.
ATTENTION!
The machine's weight alone is not
suffi cient to keep it steady.
The transported load can shift:
•
When braking;
•
When accelerating;
•
In corners;
•
On rough roads;
If slings in synthetic fi bre are used to secure the
machine, protect them against rubbing, abrasion and
damage caused by any sharp edges of the load. If there
are sharp edges that can damage the sling, use suitable
corner protectors or sliding tubes.
ATTENTION!
When removing the anchoring systems,
make sure the stability of the machine's
parts does not depend on the anchoring
and, therefore, that this operation
does not cause the load to fall off the
vehicle.
Before unloading the machine's parts
make sure all the anchoring systems
are removed.
D2
Handling
Arrange a suitable area with fl at fl oor for machine
unloading and storage operations.
D2.1
Procedures for handling operations
For correct and safe lifting operations:
handling
and
must
receive
•
Use the type of equipment most suitable for
characteristics and capacity (e.g. electric pallet truck
or lift truck);
•
Cover sharp edges;
•
Check the forks and lifting procedures according to
the instructions given on the packing;
Before lifting:
•
Send all operators to a safe position and prevent people
from entering the handling area;
•
Make sure the load is stable;
•
Make sure no material can fall during lifting;
•
Maneuver vertically in order to avoid impacts;
•
Handle the machine, keeping it at minimum height
from the ground;
D2.2
The operator must:
The operator must:
• •
Have a general view of the path to be followed;
Have a general view of the path to be followed;
• •
Stop the maneuver in case of hazardous situations;
Stop the maneuver in case of hazardous situations;
D2.3
Before placing the load, make sure the way is free and
that the fl oor is fl at and can take the load.
D3
The machine and/or its parts must be stored and
protected against damp, in a non-aggressive place free
of vibrations and with room temperature of between
-10° C / 14° F and 50° C / 122° F.
The place where the machine is stored must have a
fl at support surface in order to avoid any twisting of the
machine.
E
27
ATTENTION!
For
machine
lifting,
movable or weak parts such as:
fi lters, electrical cables, etc.
Shifting
Placing the load
Storage
INSTALLATION AND ASSEMBLY
ATTENTION!
Machine
installation,
and commissioning operations must
only be carried out by specialized
technicians
provided
necessary PPE (e.g. safety shoes,
gloves,
glasses,
equipment, tools and suitable means.
ATTENTION!
Make sure the main switch of the panel
the machine is connected to is locked
in the open "0" or off position.
do
not
use
maintenance
with
all
the
overalls,
etc.),
Werbung
Kapitel
Inhaltsverzeichnis
