Preparing The Product For Use - Ottobock 6A30-20N Gebrauchsanweisung

6A30=20N Shuttle Lock
Quantity Designation
1 Dummy set
Consisting of: 1 cap screw, 1 sleeve
dummy, 2 O-rings
Spare parts/accessories (not included in the scope of deliv­
Quantity Designation
– Pin, short
– Pin, long

5 Preparing the product for use

CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
5.1 Preparing for socket fabrication
> Required materials: Plate dummy, ratchet unit dummy, shuttle
lock housing, silicone grease, Plastaband 636K8*
1) NOTICE! Align the shuttle lock with the longitudinal axis of
the residual limb to prevent unnecessary load and wear (see
fig. 4).
Position the plate dummy on the distal surface of the plaster mod­
el along the longitudinal axis of the residual limb and secure it
with 4 nails (see fig. 5).
2) Grease the thread of the ratchet unit dummy and screw the
dummy into the shuttle lock housing.
3) Fill the slot in the head of the ratchet unit dummy with Plastaband.
Reference
number
6A94
ery)
Reference
number
6Y13=2
6A13=L1
5.2 Fabricating the prosthetic socket
Use without lamination disc
Required materials: Sleeve dummy, cap screw from 6A94
>
dummy set
1) Insert the sleeve dummy into the shuttle lock housing.
2) Secure the shuttle lock housing and sleeve dummy to the plate
dummy with the cap screw.
3) Fabricate the prosthetic socket as described in the instructions
for use of the socket attachment block or the lamination anchor.
4) Perform final assembly (see page 12).
INFORMATION
The layup described in this document was approved for the maxim­
um product user body weight. The prosthetist assumes full respons­
ibility for any change to the layup.
Use with lamination disc
Required materials: 5R2 lamination disc, 636K8* Plastaband,
>
501S74=3.5x9.5 fillister head self-tapping screws, countersunk
head screw from 5X108 dummy set, silicone grease, 99B81 PVA
bag, 623T9 Nylglass stockinette, 616G4 fibreglass mat, 616G12
carbon fibre cloth, 616G14* woven carbon fibreglass stockinette,
616G3 fibreglass woven hose, 617H119 Orthocryl lamination res­
in 80:20 PRO
1) Fill the 4 screw holes on the underside of the lamination disc with
Plastaband (see fig. 6).
2) Position the lamination disc on the shuttle lock so that the marking
hole is aligned with the ratchet unit (see fig. 7).
3) Secure the lamination disc on the shuttle lock housing with 6 fil­
lister head self-tapping screws (see fig. 8).
4) Secure the shuttle lock housing and lamination disc on the plate
dummy with the countersunk head screw.
5) Apply grease to the contact surface of the lamination dummy and
put on the lamination dummy (see fig. 9, see fig. 10).
11