Preparing The Product For Use; Instructions For Use - Ottobock 1S49 Gebrauchsanweisung

Spare parts/accessories (not included in the scope of deliv­
Fig. Item Designation
2 1 Foot adapter with screw con­
nection
2 2 Connection plate
3 – Ankle block (exoskeletal
design)
4 – Screw connection for ankle
block (exoskeletal design)
– – Ottobock special adhesive
with hardener

5 Preparing the product for use

CAUTION
Incorrect alignment or assembly
Risk of injury due to damaged prosthetic components
► Observe the alignment and assembly instructions.
INFORMATION
► Not all of the materials may be available in your country. In this
case, please contact the local branch of the manufacturer to
obtain information on alternative materials.
5.1 Installing the foot adapter
► Install the foot adapter on the prosthetic foot according to its

instructions for use.

12
ery)
Reference num­
ber
2R8*, 2R31*,
2R54*
2R14
2K34=*
2Z22=M10
636W28 or
636W18 and
636W19
5.2 Installing the ankle block (exoskeletal design)
Required materials : Screw connection (see Page 11), 710D4
>
torque wrench, 40 grit sandpaper, 617H21 sealing resin, 617P37
hardener powder, suitable solvent (e.g. 634A28), only for
1WR95: 636W17 plastic adhesive
1) Insert the threaded socket of the screw connection in the proximal
side of the hole in the ankle block.
2) Insert the screw on the foot sole side in the prosthetic foot and
screw the ankle block to the prosthetic foot (mounting torque:
30 Nm).
3) Conduct the fitting of the ankle block.
4) Loosen the screw connection between the prosthetic foot and the
ankle block.
5) Sand the ankle block according to the contour of the prosthetic
foot.
6) Roughen the connection surface of the prosthetic foot in an a – p
direction using the sandpaper.
7) Remove the dust from the sanded surfaces.
8) Mix the sealing resin with 2% to 3% hardener powder for the con­
nection between the ankle block and the prosthetic foot.
9) INFORMATION: Do not put the resin in the hole for the
screw connection.
Apply the resin evenly to the connection surfaces of the ankle
block and prosthetic foot. At least 2 applications are required
due to the absorbency of the wood.
10) When the resin is slightly cured (threads on the spatula), align the
ankle block and prosthetic foot with each other.
11) Insert the screw on the foot sole side in the prosthetic foot and
screw the ankle block to the prosthetic foot (mounting torque:
30 Nm).
12) Wipe off resin that comes out of the joint using a cloth.
13) 1WR95 only: Apply plastic adhesive to the plug for the screw
connection and press it fully into the prosthetic foot.
14) Remove any remnants of the adhesive using a suitable solvent.