Intended Use - Ottobock 6A40 MagnoFlex Lock Gebrauchsanweisung

by vacuum forming and in the definitive socket by lamination. To con­
nect to the distal prosthetic components, it is equipped with a four-
hole connector. The flexible pin is installed on the liner. When sliding
into the prosthetic socket, the magnet in the MagnoFlex Lock aligns
the flexible pin with the opening. This makes it easier to don the pros­
thesis.
1.2 Combination possibilities
This prosthetic component is compatible with Ottobock's system of
modular connectors. Functionality with components of other manufac­
turers that have compatible modular connectors has not been tested.
Limited combination options for Ottobock components
Designation
Socket adapter
Slide plate
(The 4X314 spacer plate is required in addi­
tion.)

2 Intended use

2.1 Indications for use
The product is intended exclusively for lower limb exoprosthetic fit­
tings.
2.2 Area of application
• The maximum approved body weight is specified in the technical
data (see page 18).
2.3 Environmental conditions
Allowable environmental conditions
Temperature range for use: -10 °C to +60°C
Allowable relative humidity 0 % to 90 %, non-condensing
Unallowable environmental conditions
Mechanical vibrations or impacts
12
Unallowable environmental conditions
Perspiration, urine, fresh water, salt water, acids
Dust, sand, highly hygroscopic particles (e.g. talcum)
2.4 Service life
This product was tested by the manufacturer with 3 million load
cycles. Depending on the user's activity level, this corresponds to a
maximum service life of 5 years.
3 Safety
3.1 Explanation of warning symbols
Reference num­
ber
3.2 General safety instructions
4R54, 4R77
6A41
Excessive strain on the product
Risk of injury due to breakage of load-bearing components
► Use the prosthetic components according to the MOBIS classi­
Improper combination of prosthetic components
Risk of injury due to breakage or deformation of the product
► Only combine the product with prosthetic components that are
► Based on the instructions for use of the prosthetic components,
Exceeding the service life and reuse on another patient
Risk of injury due to loss of functionality as well as damage to the
product
Warning regarding possible risks of accident or
CAUTION
injury.
CAUTION
fication.
CAUTION
approved for that purpose.
verify that they may be combined with each other.
CAUTION