9.10 Error Reports And Warning Messages - Sartorius Stedim Biotech BioWelder Total Containment TC 2000 Bedienungsanleitung

Error report
All runs blocked (X)
(X) = Error number
* The (5) Heating Error is triggered when the blade temperature has not reached the depyrogenisation temperature of < 400°C
Warning messages
Please remove tube holder
No tube holder inserted
No matching tube was found
Only one tube holder inserted
Tube holders do not match
Remove blade
Blade not inserted

9.10 Error reports and Warning messages

The following tables list all error reports and warning messages which can appear in
the operator control .
Possible cause
No. Error
0 Turning axis
1 Turning squeeze axis
2 Fixed squeeze axis
3 Cutting axis
4 Forward axis
5 Heating*
6 Fan
7 Placeholder
8 Placeholder
9 Cover lock
Run stopped by power fail
Possible cause
Tube holder inserted
1 . No tube holder inserted
2 . Contact surface of tube holder or the
spring contacts are dirty .
No welding parameters available for the
selected type of tube and the inserted tube
holder set .
1 . Only one tube holder is inserted
2 . Only one tube holder is recognized .
Tube holders with different color marking
were inserted .
Blade has not yet been removed up to now
Blade not completely inserted to back
of holder
Remedy
see Chapter 4 .5 Blocked device
Follow the instructions on the user interface .
Elimination
Tube holder removed
1 . Insert tube holder set
2 . Clean the contact surfaces of the tube
holders and those of the spring contacts with
a suitable cleansing agent
Was the right type of tube chosen?
Request new welding parameters from Sartorius
Stedim Biotech .
1 . Insert both tube holders .
2 . Clean the contact surfaces of the tube
holders and those of the spring contacts with
a suitable cleansing agent
Insert tube holders with the same color marking .
Remove blade
Insert blade
Appendix 45