User Login/Logout - Sartorius Stedim Biotech BioWelder Total Containment TC 2000 Bedienungsanleitung

30 Operation
General parameters
Tube type
Auto logout time
Language
DHCP
MAC address
Static IP address
Static subnet mask
Static default
gateway address
Static server address
Weld Log Screen
Only a specialist can modify the network settings. Improper use can cause the
machine to stop responding via the Web browser. New network parameters are
accepted when the machine is switched on and off.
6.3.6

User login/logout

Login:
If no user has the automatic login attribute, the user must log in with a user name
and password . To do this, select the user name in the Login/Logout dialogue and enter
the corresponding password . Confirm the entries by pressing the login button .
Logout:
A user logs out by pressing the Logout button on the machine .
If a user has the automatic login attribute, then this user is automatically
logged in every time the device is started or after switching modes between
touch screen and Web browser. Automatic logout is than deactivated.
Description
Preset standard tube type
After the specified time, the BWTC logs out automati-
cally if no user activity happens
Operator control language
The language is updated in the operator control when
the machine is switched on and switched off .
If the device is connected to a DHCP server and the
user would like to work with a dynamically assigned IP,
the check box must be activated .
This address only needs to be adjusted if two devices in
the same network have the same MAC address . The
MAC addresses are assigned by the manufacturer and
every device has its own address .
If the DHCP is off, then the user with this address can
log in on the machine via Web browser
Subnet mask of the local network
Address of a possible gateway
Address of the DHCP server Is used if DHCP is activated .
If check box is active, a weld log screen will be shown
after each weld with according informations .