Control Terminals; Accessing The Control Terminals; Setting The Control Terminals To Run The Compressor - Danfoss VLT Compressor Drive CDS 803 Bedienungsanleitung

VLT® Compressor Drive CDS 803
Operating Guide

3.2.6 Control Terminals

3.2.6.1 Accessing the Control Terminals

Procedure
1.
To activate the snap, place a screwdriver behind the terminal cover.
Illustration 6: Removing the Terminal Cover
2. Tilt the screwdriver outwards to open the cover.

3.2.6.2 Setting the Control Terminals to Run the Compressor

12 20 55
20 27 29 42 45
Illustration 7: Overview of the Control Terminals
Procedure
1.
Apply a start signal on terminal 18.
2. Connect terminals 12, 27, and terminal 53, 54, or 55.
3.
Set the functions of digital inputs 18, 19, and 27 in parameter 5-00 Digital Input Mode (PNP is default value).
4.
Set the function of digital input 29 in parameter 5-03 Digital Input 29 Mode (PNP is default value).
18 | Danfoss A/S © | 2019.12
OFF
50 53 54 55
BUS TER.
ON
61 68 69
AQ32174876762701-000101 / 130R0627
Installation