VLT® Compressor Drive CDS 803
Operating Guide
•
Use a shielded/armored motor cable to comply with EMC emission specifications and connect this cable to both the decoupling
plate and the motor.
•
Keep the motor cable as short as possible to reduce the noise level and leakage currents.
•
For further details on mounting the decoupling plate, see VLT® Compressor Drive CDS 803 Decoupling Plate Installation Instruc-
tion.
•
Also see EMC-correct Installation in the
3.2.3.2 Connecting to Mains and Motor
1.
Mount the 2 screws in the mounting plate, slide the plate into place, and tighten fully.
2.
Mount the ground cables to the ground terminal before mounting other cables.
12 | Danfoss A/S © | 2019.12
1.3.2.5 EMC-correct Electrical Installation
Installation
AQ32174876762701-000101 / 130R0627