Program Description - Bosch EPS 625 Originalbetriebsanleitung

5.

Program description

5.1 Description of keys on the HMI
Control key Designation
symbol
test oil pump on
/ off
Lubricating pump
on / off
Direction of motor
rotation
2)
Drive motor on
Heater on / off
Temperature selec-
tion
RPM selection
Drive motor off
Increase
4)
Decrease
4)
Stroke counter se-
lection
3)
Stroke counter on
/ off
Backspace
Enter
Tab. 3: Description of control keys on th e HMI#
In view to the shaft of the injection pump
1)
Only possible when test oil pump is turned off
2)
No change possible during stroke counting
3)
When holding down the button, the value first changes in
4)
increments of 1, then ten times in increments of 10, and then in
increments of 100.
Robert Bosch GmbH
Explanation
Switch on/ off the test oil
pump
Switch on/ off the lubrica-
tong pump
Change the direction of
the motor rotation
Start drive motor.
2)
Switch on/ off the heater
2)
Change the set temper-
ature of the test oil tank
and the inlet/ outlet of the
fuel injection pump
Change the set RPM
3)
Stop drive motor.
Navigation within con-
trol panel and change of
speed, stroke rate and
temperature values
Navigation within con-
trol panel and change of
speed, stroke rate and
temperature values
Change the set stroke
counter
Switch on/ off the stroke
counter to calculate the in-
jection amount
Exit a menu and go back
up one level
Confirm selection or ac-
cept displayed value
Program description | EPS 625 | 63
Fig. 25: Control buttons
5.2 Operation of the HMI
¶
Switch on the EPS 625.
 The HMI is powered on. Wait until the default
screen is displayed.
 A typical view of the default screen is depicted
below.
Fig. 26: Example default screen
en
|
1 689 988 258 2017-05-30