Changing The »Permanent Access« Key - G&D DLVision-DP Handbuch

Changing the »Permanent Access« key
After you have pressed the key combination to operate the extender exclusively, the
input devices at the concurrent console are deactivated.
Only after the key combination has been pressed again at the active console, both
consoles can operate the KVM extender again.
The key combination for the exclusive operation consists of at least one hotkey
modifier (see Changing the hotkey on page 27) and one additional exclusive key,
which can be selected by the user.
You can change the hotkey modifier
How to change the current exclusive scancode:
1. Press the key combination
enable the setup mode.
If the hotkey delay is active, press the key combination during the adjusted time (default:
7 seconds).
2. Press the setup key
3. Press the key of the exclusive scancode to be adjusted.
The following keys are provided: Backspace, Print, Scroll, Num, Pause, Insert,
Delete, Pos 1, End, PgUp, PgDn and Space.
1. Use the tree view to click on
2. Double-click the computer module of the KVM extender to be configured.
3. Click the General
4. Use the field
The following keys are provided: Backspace, Print, Scroll, Num, Pause, Insert,
Delete, Pos 1, End, PgUp, PgDn and Space.
5. Click to save your changes.
OK
as well as the »Permanent Access« key
Ctrl
Hotkey+Backspace
.
X
KVM Extenders > [All Extenders]
tab.
Exclusive mode actionkey
(default:
.
to select the desired key.
G&D DL-Vision-DP · 29
Configuration
.
Print
) to
Ctrl + Backspace