Getting Started; Start-Up; On-Screen Display At User Module - G&D DLVision-DP Handbuch

Getting started

Getting started
After the KVM extenders have been properly installed, they can be immediately put
into operation.
Mind the following activation sequence while initiating the extenders:
1. Switch on the user module
2. Switch on the computer module
3. Switch on the computer that is connected to the computer module.
NOTE: The recommended activation sequence for the initiation ensures that the
KVM extender is able to read out the features of the connected monitor and to
transmit them to the computer (see E-EDID transmission with cache function on
page 44).

Start-up

After the computer and user module has been switched on, the LEDs on the front
panel indicate the module's operating status.
More information on this topic is given in the chapter Status displays on page 51 ff.

On-screen display at user module

The starting screen of the user module displays additional information about the start-
up, the firmware versions, and the IDs of the connected modules.
14 · G&D DL-Vision-DP
DL-Vision-DP-CON .
DL-Vision-DP-CPU .