Installing The Computer Module - G&D DLVision-DP Handbuch

Installation

Installing the computer module

The computer, whose signals are transmitted to the remote console, is connected to
the
DL-Vision-DP-CPU
to the computer module.
ADVICE: Connect the cables to the computer module preferably from left to right.
By doing so, you will avoid already connected cables blocking your view of the
interfaces.
Establishing a connection to up to two local networks
Mouse
Keyb. USB K/M
NOTE:
If desired, connect the network interface to up to two local networks. Now
you can not only access the
also send syslog messages to those networks.
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Connecting keyboard and mouse to the local console
NOTE:
If you want to create a local console at the computer module, connect
either PS/2 (Mouse or Keyb. interfaces) or USB devices (USB K/M interfaces).
Mouse: Connect the PS/2 mouse of the local console.
Keyb.: Connect the PS/2 keyboard of the local console.
USB K/M: Connect the USB mouse and/or the USB keyboard of the local console.
6 · G&D DL-Vision-DP
computer module. A local console can optionally be connected
Mouse CPU
Keyb. CPU USB CPU Transmission
Config Panel
Mouse CPU
Keyb. CPU USB CPU Transmission
Link
Video
DisplayPort CPU
DVI-D DL Out
web application from those networks but
Link
Video
DVI-D DL Out DisplayPort CPU
Line In Line Out
RS232
RS232 Line In Line Out