Establishing The Power Supply; Installing The User Module - G&D DLVision-DP Handbuch

Installation

Establishing the power supply

DisplayPort CPU RS232
Main Power: Insert one of the supplied PowerCable-2 Standard IEC cables here.
Red. Power: Insert one of the supplied PowerCable-2 Standard IEC cables here. This es-
tablishes a second, redundant power supply for the user module.

Installing the user module

The remote console is connected to the
puter connected to the computer module can be operated over this console.
ADVICE:
Connect the cables to the computer module preferably from left to right.
By doing so, you will avoid already connected cables blocking your view of the
interfaces.
Establishing a connection to up to two local networks
Network B Mouse
Network A Keyb. USB K/M
NOTE: If desired, connect the network interface to up to two local networks. Now
you can not only access the
also send syslog messages to those networks.
Network A: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
Network B: Insert a category 5 twisted pair cable (or better), which is available as acces-
sory. Connect the other end of the cable to the local network.
10 · G&D DL-Vision-DP
USB 2.0 Trans. USB 2.0 CPU
Ident.
Line In Line Out Power Card
RS232 Transmission
Config Panel
Power
Red.
Main
DL-Vision-DP-CON
Link
Video
DisplayPort Out Micro In Speaker Control Panel
web application from those networks but
user module. The com-
USB 2.0 Devices
Ident. Power
Red.
Main