G&D DLVision-DP Handbuch Seite 78

Installation
Transmission|Tx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Rx interface of the computer module.
Transmission|Rx: Insert the LC plug of the fibre optic cable, which is connected to the
Transmission|Tx interface of the computer module.
NOTE: Each video channel of the MultiChannel variant is provided with one
interface. The numbers behind the interface names assign each interface to a
sion
given channel.
Additional interfaces of expanded variants
RS232
IMPORTANT: The interfaces listed in this paragraph are only provided at certain
variants.
Connect a microphone to this interface if desired.
Micro In:
Speaker: Connect the console speakers or another audio output device to this interface.
RS232: Connect the serial end device to this interface.
NOTE:
Each video channel of the MultiChannel variant is provided with one
interface. The numbers behind the interface names assign each interface to a given
channel.
USB 2.0 Devices: Connect any USB device to these four interfaces.
IMPORTANT: Transmission modules transmit the data of the USB devices con-
nected to the USB 2.0 Devices interfaces at the user module between the user module
and the computer module (and vice versa). Those transmission modules use laser
technology complying with laser class 1.
Please note the following safety instructions regarding this matter:
 Only use G&D certified transmission modules on page 2
USB 2.0 Trans.|Tx:
USB 2.0 Trans.|Rx interface of the computer module into this interface.
USB 2.0 Trans.|Rx:
USB 2.0 Trans.|Tx interface of the computer module into this interface.
12 · G&D DL-Vision-DP
Link
Video
Transmission DisplayPort Out
Plug the LC plug of the fibre optic cable, which is connected to the
Plug the LC plug of the fibre optic cable, which is connected to the
Ident. Power
Micro In Speaker Control Panel
Transmis-
USB 2.0 Devices USB 2.0 Trans.
Red.
Main
RS232