Enabling Or Resetting A Ps/2 Mouse - G&D DLVision-DP Handbuch

Enabling or resetting a PS/2 mouse

NOTE: These functions can only be perform in the setup mode.
Unlike USB mouse devices, PS/2 mouse devices do not support the hot plug tech-
nology. You can therefore insert the PS/2 plug during operation but it may be pos-
sible that the computer does not detect the input device.
To activate or reset the PS/2 mouse, the KVM extender can send a special com-
mand to the computer.
Since the commands differ depending on the used mouse type and the installed ope-
rating system, we provide four different setup keys.
How to activate or reset the PS/2 mouse:
1. Press the key combination
enable the setup mode.
If the hotkey delay is active, press the key combination during the adjusted time (default: 7
seconds).
2. Press one of the setup keys listed below to enable or reset a particular PS/2
mouse:
M  PS/2 mouse of a Linux computer
 PS/2 wheel mouse of a Linux computer
I
E  PS/2 wheel mouse with additional keys of a Linux computer
R  PS/2 mouse interface of a Windows computer
(default:
Hotkey+Backspace
Configuration
) to
Ctrl+Backspace
G&D DL-Vision-DP · 41