Freeze Mode - G&D DLVision-DP Handbuch

Configuration

Freeze mode

If the cable connection between computer and user module fails during operation, the
KVM extender no longer displays an image at the console monitor.
Enable the Freeze mode if you want the last available image at the user module to be
displayed after the connection was interrupted. The image will be displayed until the
connection is re-established.
The Freeze mode supports two different operating modes:
 Enabled (with buffer):
is still available in case of a disconnection. There might be minimum latencies
when displaying the image. However, these latencies cannot be perceived by the
human eye.
 Enabled (without buffer):
console monitor without any latencies. In case the connection is interrupted, the
image might not be displayed completely.
ADVICE: If you use shutter glasses to view 3D images and want to use the Freeze
mode, choose the mode
To highlight a failed connection, the last available image can be displayed with
either a coloured frame and/or a
tion failed.
How to configure the freeze mode:
1. Click on KVM Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender to be configured.
3. Click the
Remote
The Freeze mode can be disabled/enabled for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
4. Use the
Freeze mode
above):
(default)
Disabled
Enabled (with buffer)
Enabled (without buffer)
5. If the Freeze mode is disabled, you can use the
ble the following options.
Frame
OSD
6. Click to save your settings.
OK
34 · G&D DL-Vision-DP
Buffering an image ensures that a complete and proper image
When disabling the buffer, the image is displayed at the
without buffer
Frozen
tab.
box to choose between the following options (see
 shows a coloured frame when disconnected.
 shows Frozen when disconnected.
.
popup and the time passed since the connec-
in the tree view.
Freeze visualization
box to disa-