Defining The Time Out; Enabling The Protected Mode - G&D CATVision Installation Und Bedienung

Guntermann & Drunck GmbH
6.2.2.7

Defining the Time Out

With this setting you define the delay time you define how long the blocked
console stays inactive unless at the active console no Keyboard/Mouse action
can be mentioned. The other console can have access to the system again,
after the in this chapter defined time-out after the last keyboard/mouse action
has exceeded.
Move the cursor to the entry Timeout.
By entering a value in the range of 1 to 90 seconds you can define the delay
time.
For saving the settings and closing the menu press
6.2.2.8

Enabling the Protected Mode

In default condition of the Protected Mode all connected console are locked for
keyboard and mouse action and all monitors are switched dark (see
7.4). Only by pressing the hotkeys
reserve the right for operation. Whilst this exclusiv operation of the active
console, the monitor of the inactive console remains dark and no keyboard and
mouse operation are possible.
With this setting you define whether the Protected Mode (see
enabled or not.
Move the cursor to the entry Protected Mode.
SPACE
By pressing
For saving the settings and closing the menu press F1. After you have finished
all settings the Protected Mode is activ.
After enabling the Protected Mode the following window appears on the
monitor.
CVM
PROTECTED MODE ENABLED
(CTRL +
you can chose between Yes or NO.
page 40
Operating Instructions
F1
.
Print), a console can exclusivly
chapter
CATVision (MC)
chapter
7.4) is