Freeze Mode - G&D VisionXS-C-DP-UHR Installation Und Bedienung

Configuration

Freeze mode

If the cable connection between the computer module and the user module is inter-
rupted during operation, the KVM extender no longer displays an image at the remote
console.
Enable the Freeze mode if you want the last image that has been displayed at the user
module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a
connection has been interrupted.
How to configure the Freeze mode:
1. Press
Ctrl+Num
2. Select the row
3. Under
Freeze mode
off  Freeze mode is disabled (default)
 Freeze mode is enabled
on
4. If the Freeze mode is active, press
under Freeze visualization
frame
OSD
frame+OSD
5. Press to save your settings.
F2
1. In the menu, click on
2. Click twice on the computer module (
3. Click on the tab
4. In the Freeze mode
Off
On | OSD timer + frame
On | Frame
On | OSD timer
5. Click on Save
43 · G&D VisionXS-C-DP-UHR
(default) to open the on-screen display.
Console setup and press
press to select on of the following options:
F8
:
 shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
 shows a coloured frame (
KVM extender
.
Video channels
field, select one of the following options:
 Show no image if the connection is lost (default).
 Display of a coloured frame in case of a
disconnection as well as display of the warning
Frozen and the time elapsed since the
disconnection.
 A disconnection is indicated by a coloured frame.
 Display of the warning Frozen and the time
elapsed since the disconnection.
.
Frozen popup and the time passed since the
Enter .
F8 to select one of the options available
frame ) and Frozen (
.
CPU ) you want to configure.
OSD )