Freeze Mode - G&D VisionXS-F-DP-UHR Installation Und Bedienung

Freeze mode

If the cable connection between the computer module and the user module is inter-
rupted during operation, the KVM extender no longer displays an image at the remote
console.
Enable the Freeze mode if you want the last image that has been displayed at the user
module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a
connection has been interrupted.
How to configure the Freeze mode:
1. Press
Ctrl+Num
2. Select the row
3. Under Freeze mode
off  Freeze mode is disabled (default)
 Freeze mode is enabled
on
4. If the Freeze mode is active, press
under Freeze visualization
frame  shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
OSD
 shows a coloured frame (
frame+OSD
5. Press F2 to save your settings.
1. In the menu, click on
2. Click twice on the computer module (
3. Click on the tab
4. In the
Freeze mode
Off
On | OSD timer + frame
On | Frame
On | OSD timer
5. Click on .
Save
Frozen
(default) to open the on-screen display.
and press
Console setup
press F8 to select on of the following options:
to select one of the options available
F8
:
KVM extender .
Video channels .
field, select one of the following options:
 Show no image if the connection is lost (default).
 Display of a coloured frame in case of a
disconnection as well as display of the warning
Frozen and the time elapsed since the
disconnection.
 A disconnection is indicated by a coloured frame.
 Display of the warning Frozen and the time
elapsed since the disconnection.
popup and the time passed since the
.
Enter
) and Frozen (
frame OSD
CPU ) you want to configure.
G&D VisionXS-F-DP-UHR · 44
Configuration
)