Freeze Mode - G&D DP-Vision-Fiber Installationanleitung Und Betriebsanleitung

Freeze mode

If the cable connection between the computer module and the user module is inter-
rupted during operation, the KVM extender no longer displays an image at the remote
console.
Enable the Freeze mode if you want the last image that has been displayed at the user
module to be available until the connection is re-established.
To highlight an interrupted connection, the last available image can be displayed
with either a coloured frame and/or a
connection has been interrupted.
How to configure the Freeze mode:
1. Press Ctrl+Num
2. Select the row
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
3. Under
Freeze mode
off  Freeze mode is disabled (default)
 Freeze mode is enabled
on
4. If the Freeze mode is active, press
under
Freeze visualization
 shows a coloured frame when disconnected
frame
OSD  shows Frozen and the time passed since disconnection
 shows a coloured frame (
frame+OSD
5. Press F2 to save your settings.
Frozen
(default) to open the on-screen display.
Console setup and press
press to select on of the following options:
F8
to select one of the options available
F8
:
popup and the time passed since the
Enter .
frame ) and Frozen ( OSD
G&D DP-Vision-Fiber · 34
Configuration
)