AVENTICS | AES I/O Modules, Analog | R412018147–BAL–001–AG
6.2.3
Output module 2AO2M12E
The output module diagnostic message consists of a diagnosis bit.
The diagnostic bit can be read as follows:
Bit = 1: An error has occurred.
Bit = 0: No error has occurred.
The diagnosis bit is sent for the following errors:
with a diagnostic message from the driver of an output channel,
– due to driver overheating,
– or overload in the "voltage output" mode,
– or wire break in the "current output" mode
6.2.4
Pressure measurement module 4P4D4/4VP4D4
The pressure measurement module diagnostic messages consist of a diagnosis bit. The diagnostic
bit can be read as follows:
Bit = 1: An error has occurred.
Bit = 0: No error has occurred.
The diagnosis bit is sent for the following errors:
If a pressure sensor is defective
Structure of the I/O Module Data
87