Input Module 4Ai4M12E; Electrical Connections; Leds - Aventics AES Serie Systembeschreibung

Power supply
Functional earth connection
12
Input connections
UL
X2N1
AVENTICS | AES I/O Modules, Analog | R412018147–BAL–001–AG
4.2

Input module 4AI4M12E

4.2.1

Electrical connections

The bus coupler supplies power for the input module via the electrical backplane connections (13)
and (15). The module does not contain any additional power supply connections.
To discharge EMC interferences, connect the FE connection (12) to the I/O module via a
low-impedance line to functional earth. The cable cross-section must be selected according to
the application.
The input module is equipped with 4 input connections for sensors. These are designed as M12
sockets, female, 5-pin, A-coded.
The connection ID for
input channel 1 is X2N1,
input channel 2 is X2N2,
input channel 3 is X2N3,
input channel 4 is X2N4.
The sensor voltage is supplied via pin 1 and pin 3.
See Table 8 for the pin assignments of the input connections X2N1 to X2N4.
Table 8: Pin assignments of input connections
Pin Sockets X2N1 to X2N4
1)
1 24 V DC sensor voltage
2 Input signal, positive input
3 0 V DC sensor voltage
4 Input signal, 0 V, connected to pin 3 internally
5 Shield, connected internally with ground screw (12)
1)
Derived from the UL voltage
The cable from the device to connections X2N1 to X2N4 must be shielded. The shield must be
connected to pin 5.
The cable length must not exceed 30 m. The total current for all sensor supplies on an input module
must not exceed 0.5 A.
Maximum input voltage on the signal inputs:
Voltage measurement range: ±15 V
Current measurement range: ±5 V
4.2.2

LEDs

The I/O modules have only module-related LEDs and no channel-related LEDs. The module-related
LEDs (1), (2), and (3). are for voltage and diagnosis monitoring.
The channel-related LEDs (9) are not present with analog modules; however, the semi-circular
optical conductors are visible due to the design.
79
About This Product