Maintenance; Routine Maintenance - Frigomat T4S Serie Gebrauchsanweisung Und Wartungshandbuch

7. MAINTENANCE

7.1 ROUTINE MAINTENANCE (INTENDED FOR USER)
The fats present in the ice cream mixtures are ideal fields for the proliferation of bacterial
loads and mould. To eliminate this serious problem, all the parts which come into contact
with the product must be thoroughly washed and sanitised by careful procedures and
using suitable sanitising products. The stainless and plastic materials used on our
machines, in fact, comply with the strictest international provisions and their special shape
facilitates their washing. However this is not enough to prevent the formation of mould and
bacteria caused by insufficient or incorrect cleaning.
FRIGOMAT recommends thoroughly washing and sanitising the parts in direct contact with
the product after each work shift and in compliance with hygienic standards in force in the
Country where the machine is installed.
To correctly clean your machine, refer to the following operations:
PREWASHING
• Pour
the maximum
(approximately 50°C)
machine.
• Press the ESTRAZIONE (EXTRACTION) button in
order to start the beater motor and let it run for about
3'. Open the dispenser disk to drain all the wash
water. Repeat the procedure until the water coming
out is clear and clean.
• Pour
the maximum
cleansing/sanitising solution into the machine.
• Press the ESTRAZIONE (EXTRACTION) button in
order to start the beater motor and let it run for about
15'. Open the dispenser disk to drain all the
sanitising solution.
We suggest using the following sanitising
solution:
Ecolab P3 Topax-san
(4% dilution = 200 ml).
admitted load of
drinking water into
load admitted
ENGLISH - 28
warm
the
of