Automatic Hard Cycle - Frigomat T4S Serie Gebrauchsanweisung Und Wartungshandbuch

6.3.2 AUTOMATIC HARD CYCLE

Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
The machine stores the last program selected in its memory. If the HARD cycle has been
selected, this is automatically recalled every time one presses the PRODUCTION key. To select
the Automatic cycle again refer to the following instructions:
- During batch freezing, press the PRODUCTION key again.
- The LEDs of the UP, Confirm and DOWN keys light up and the HRD message relative to the
cycle in progress is viewed on the display.
- Press the DOWN key once until the AUT message is viewed on the display that distinguishes
the automatic cycle. Press Confirm to activate a new cycle.
- Press the PRODUCTION key to start the automatic
batch freezing cycle, as described in the previous
section.
- The AUT message is viewed on the display for a few
seconds to confirm the automatic cycle has been
selected
- To activate the automatic Hard cycle, press the
PRODUCTION key again (Fig. 1).
- The LEDs of the UP, Confirm and DOWN keys light
up and the AUT message relative to the cycle in
progress is viewed on the display. (Fig. 2-3)
- Press the UP key once until the HRD message is
viewed on the display that distinguishes the automatic
HARD cycle (Fig. 4-5). Then press the Confirm key to
activate a new cycle.
- After a few minutes and once the optimal consistency
level relative to the type and quantity of introduced
mixture has been reached, an intermittent acoustic
signal warns the operator that it is possible to extract
the ice cream. If this should not be immediately
possible, the machine will automatically see to
maintain the ice cream over time without changing its
consistency any further.
- It is possible to go to the product extraction phase at
any time.
The automatic HARD batch freezing cycle is
particularly recommended in the following cases:
- Mixtures with high content of sugar and fat
- Milk and/or alcohol-based cream mixtures
- High amounts
ENGLISH - 18