Coffee Slush Program - Frigomat T4S Serie Gebrauchsanweisung Und Wartungshandbuch

6.3.6 COFFEE SLUSH PROGRAM

Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
25 - ENGLISH
- Press the SLUSH key (fig.1).
- The LEDs of the UP, Confirm and DOWN keys
light up and the GR1 message (fig. 2) is viewed on
the display.
- Press the UP key to view the GR2 message on
the display that distinguishes the slush production
program with processing time control and cyclic
mixing (fig. 3-4).
- Press the CONFIRM key to accept the selection of
program GR2.
- The LEDs of the UP, Confirm and DOWN keys
light up and the numbers relative to the time
setting to be configured appear on the display,
expressed by a numerical value between 1' and
10'. Press the UP and DOWN keys to increase or
decrease the value. High processing times
correspond to higher consistencies, low times
correspond to lower consistencies (fig. 5).
The maximum programmable time value is equal to
10 minutes but not all mixtures and not all quantities
can reach such a high consistency value.
For low amounts of mixture do not select time in
excess of 3-5 minutes.
- Subsequently, press the Confirm key to start a
new slush production cycle (fig. 6).
- During the GR2 production cycle the compressor
always keeps running, whilst the beater will
operate in cyclic mode to reduce the incorporation
of air in the mixture.
- After the programmed time has elapsed, an
intermittent acoustic signal warns the operator that
it is possible to extract the product.
The GR2 program DOES NOT envisage the
automatic preservation of the product at the end of
the production cycle.