Semi-Automatic Cycle With Consistency Control - Frigomat T4S Serie Gebrauchsanweisung Und Wartungshandbuch

6.3.3 SEMI-AUTOMATIC CYCLE WITH CONSISTENCY CONTROL (only for experts)
Fig.1
Fig.2
.
Fig.3
Fig.4
Fig.5
19 - ENGLISH
- Press the PRODUCTION key, as described in the
previous sections.
- The AUT or HRD message is viewed on the display
for a few seconds to confirm the automatic or
automatic HARD cycle has been selected.
- To activate the semi-automatic cycle with consistency
control, press the PRODUCTION key again.
- The LEDs of the UP, Confirm and DOWN keys light
up and the AUT or HRD message relative to the cycle
in progress is viewed on the display (fig. 1).
- Press the UP key until the SAC message is viewed on
the display that distinguishes the semi-automatic cycle
with consistency control. (fig. 2-3). Then press the
Confirm key to activate a new cycle.
- The numbers relative to the consistency setting to be
configured appear on the display, expressed by a
numerical value between 60 and 250: press the UP
and DOWN keys to increase or decrease this value
(fig. 4). Higher consistencies correspond to high
numbers, lower consistencies correspond to low
numbers.
The maximum programmable consistency value is equal
to 250 numbers but not all mixtures and not all quantities
can reach such a high consistency value.
For a reduced amount of mixture it is recommended to
not select consistency numbers close to 250.
- Subsequently, press the Confirm key to start a new
batch freezing cycle (Fig. 5).
After a few minutes and once the consistency level
-
selected during the programming phase has been
reached, an intermittent acoustic signal warns the
operator that it is possible to extract the ice cream. If
this should not be immediately possible, the machine
will automatically see to maintain the ice
- It is possible to go to the product extraction phase
at any time.