Frigomat T4S Serie Gebrauchsanweisung Und Wartungshandbuch Seite 61

Fig.1
Fig.2
Fig.3
Fig.4
In order to correct any initial programming errors,
during the execution of the semi-automatic cycle it is
always possible to vary the time setting via the
following procedure:
- With the cycle in progress, press the SEMI-
AUTOMATIC TIME CYCLE key (fig. 1).
- The LEDs of the UP, Confirm and DOWN keys
light up and the time value is viewed on the
display: press the UP and DOWN keys to correct
the value (fig. 2-3).
- Press the CONFIRM key to validate the new data
and exit programming (fig. 4).
If one sets a batch freezing time that is too high or if
the product reaches
consistency value before the programmed time has
run out, the display automatically clears any residual
time and signals that it is possible to proceed with
extraction.
its maximum admitted
ENGLISH - 22