Address - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
The display only shows 2 lines, so to scroll through the entries and access each of
the submenus, use the side buttons as described in paragraph
GENERAL QUESTIONS REGARDING READING THE DISPLAY.
The selected entry will be highlighted by an arrow on the left-hand side of the
display. Once the chosen entry is selected, press ENTER to enter its submenu.
5.5.6.1

Address

Using this function, you can set the addresses for the communication of individual
inverters connected to the system on the RS485 line. The numbers assigned can go
from 2 to 63. Use the UP and DOWN keys to scroll through the numbers.
"AUTO" selection cannot be used at the moment
Address
Display settings
Service
New Password
Currency
Date/Time
Language
Vstart
Autotests
Alarm
Remote control
UV Prot.time
MPPT
Alarm Message
New Address
63
65 97
Page of
AUTO
2
3
.....
.....
62
63
AUTO